Anyone here remember or know what the thread size is on the 1952-1964 Evinrude/Johnson 3 HP outboard fuel outlet bung? I'm guessing it may be 3/8" NPT.
Thanks to all that can give the size.
The reason I need an answer is the fuel tank leaks at the petcock, and there is a new one on...
I've given up on trying to start /run this old outboard. I bought new coils and installed. cleaned up the points with new condensers. I thinking one of all condensers may be bad, as I have read on here the condensers from China are not good.
So, I ordered two Nova II ignition modules and there...
I'm getting around to install new coils (2) on this 1958 Evinrude Lightwin 3 HP. The old original ones were cracked, and dried to a crisp. I got one side ( coil to top spark plug and have continuity, meaning I got the coil wire inserted into the coil wire hole correctly. When I install the other...
I'm going to restore my old Evinrude to (or try) original colors. I've searched high and low for spray (rattle can) matching color paint. There are three colors on this outboard... Polychromatic Blue, Commodore Blue and Aqua White. I would like to get these paints as near (match) as possible to...
Just bought a very good vintage 1940 Johnson Seahorse At-10 5 hp motor. So far, the only thing wrong is the pull card (frayed) in the recoil start assembly.
You know something will probably happen when the day is sunny, warm, and no wind to blow you off the lake. That was the case today, only there is a minor flaw just about to happen.
I launched the boat, trolling across the lake and about in the middle (1/4 mile from shore) the trolling motor...
For over thirty years I owned a 18' Skeeter Bass Boat with 150 hp engine, and it was safe to walk around the deck and not fall out of the boat. Well: I sold that boat rig several years past and this winter got the fishing urge again. So, in February I found this old 1957 AlumaCraft 14 ft...
I have a 2002 Minn Kota Turbo 90 40 lb. 36" shaft Transom trolling motor the lower ..arm. assembly needs replacing, and there is no replacement available from Minn Kota.
So, here is my thinking...at this time it appears it may be the solution....Buy a Minn Kota Maxxum 55 lb. #2887099...
I'm rebuilding a 1957 Aluma Craft 14' 5" aluminum boat for small watershed lakes in my area. These lakes are no more than 30 to 50 acres in size.
I'm searching for a Transom mount that I can install on the bow. This would mean I would take the "head" and turn it 180 degrees and mount in.
Does...
This is my first post here. I just bought a old AlumaCraft 14' aluminum V-Bottom for $150.00. The trailer under it is something to be desired, or someone knew how to make a homemade boat trailer.
Anyway, here's my reason to come here and ask some question.
The number that is stenciled into...
