Bought a 94 bayliner with sport jet 90. Boat idles and runs smooth but when you throttle the boat it won't go over 10mph and won't plane. I have been reading forums and seems my problem may be the trigger. I pulled it out and did a ohm test. Not sure what it should read so if someone could...
i have a mercruiser 350 that im in the process of doing thru hull exhaust on.my question is will it work with the tips above the risers?thanks for any help
i have been having problems with my boat bogging at wot.been going through everything eliminated a fuel issue.now im into the electronics.my question is i have the thunderbolt ignition when i took the coil off to inspect it i seen it was the old type for external resistor could this be my...
im going to pull my 4.3 just found out the blocks cracked and low compression.so my question is im just going to buy one from a truck so what year range do i need to stay for everything to bolt right up.thanks
i got a 89 larson with the 4.3 mercruiser.took the boat out for the first time and run really bad died while idling i could play with the throttle and get it to take off but would only run at low rpms and stall when i backed out of the throttle.took it home and pulled the fuel filter out of the...
I Have A 93 Kawasaki Ts 650 The Problem Is When Running The Ski There Is Alot Of Oil Coming Out The Exhaust.is This A Major Problem Or I Thought About Taking The Oil Injectio Off And Mixing My Own Oil.any Help Would Be Great Thanks Ben.
i have a 1979 mercruiser 898.At wot it is hard to steer.also it does have power steering.Do you think this is a problem in the power steering?or should i look at other componets. thanks for any input ben
i have seen a few similar questions but not sure if this is the same problem. i have a 79 mercruiser 898 just put a motor in it i took it out for the first time tonight and when i put the boat in it got stuck in reverse i turned the motor off and it went right in to neutral and it does the same...
i have a 79 mercruiser 898 which is the 5.0 does anyone have a illustration of how the rear mounts on the bellhousing go. what i mean is where does the spacer go and fiber washer and also the spring looking washer when i pulled the motor mine had allready vibrated loose and was just laying under...