Recent content by blooka

  1. B

    Johnson 25hp 25R72R question

    Hi I have a johnson 25hp 25r72r which i think has been converted to longshaft. when i replaced the impellor i noticed there is a spacer which has 2 o rings on either end that goes over the gear selector rod. this spacer seems to be too short as one end doesn`t seem long enough to locate into...
  2. B

    Johnson seahorse inner exhaust question

    Hi i own a 25hp seahorse 25R72R and have removed the inner exhaust to find it is very corroded. Should this tube be blanked at the end with the gases going out of the small holes drilled in the side of the tube, as mine has a hole straight down the centre and i am not sure if this is how it...
  3. B

    Johnson 25HP Exhaust gases go?

    Hi i own a johnson 25hp 1972 25R72R I was just wondering do all the main exhaust gases go through the front holes where the telltale is or do they go through the prop or some other hole aswell thanks Dave
  4. B

    Stern Bracket Johnson 25hp 1972?

    Hi I have a johnson 25 hp 1972 model 25r72r the transom stern bracket is bust on on side. part no. 0383949 I have the chance of buying a similar bracket from a 1983 model j25elctd have been told it should fit but it looks slightly different anyone any ideas many thanks Dave
  5. B

    Mercury 7.5 hp which coil?

    I need two coils for my mercury 7.5 hp outboard and dont know the part number for them as i dont have the original coils. the serial number for the outboard is 3193695 i have found 2 coils that were from a similar engine but it had a cdi ignition and mine has points... would these be ok? I...
  6. B

    Evinrude 9.5 can i make it shortshaft??

    hi Just bought an evinrude 9.5 hp (9023c) outboard which is longshaft I was told that my boat should really have a shortshaft motor on it, so i was wondering if it is possible to convert it to shortshaft And what parts if any would i need to purchase to do the job. I am new to boating so any...
See more
Top