here's the deal, I have a 1977 mercury 1150 with a bad ignition coil. This motor uses a single coil for all 6 cylinders. The price of a new coil is $140. What i would like to know is does anyone know of a substitute coil that i may be able to use from an auto parts store?? Or is there an...
I have a 1977 terry 17 1/2 ft bass boat with a mercury 1150 motor. I'm looking for suggestions as to what prop would be good for this set up as the boat didn't have a prop on it when i bought it. I think it should use a 12 3/4 x ? pitch. throw some ideas out to me.
I have recently purchased a 1976 Delhi Terry 5.2, its 17 1/2 feet long with a mercury 1150. upon cleaning it out for a rebuild I found in the bilge two strips of plywood that are about 4" wide and are on each side of the bilge laying flat and running about 8 feet from the stern going towards the...
i have a 1977 1150 mercury outboard. Two wires go from the stator to a phillips head connection then to a 3 pole rectifier. these wires are yellow with red stripe. my question is when they are connected to the rectifier does it matter as to which to non positive terminal that i connect them to...
does anyone have a correct diagram or pics of fuel line routing from where the line enter the outside of the motor to its complete layout under the motor cover ? its a 1977 1150 mercury tower of power inline 6 cyl. when i bought the boat the fuel line had no ball primer and was cut or rotted...
Hello, im new to this forum as i just purchased a 1977 terry 5.2 bass boat. it has a mercury 1150 115hp motor. i want replace the distributor cap but the cheapest i found was $105. Its discontinued from mercury. Does anyone know if theres a cheaper aftermarket cap cap or a totally different...
