Want thoughts on this engine, it is a 94 GM 4.3L, it has 175K and good compression across all cylinders. My friend wants to put this in his boat to replace the cracked engine he has. I dont think its a good idea, I feel $300 is too much for it. It has been sitting for 6 months. I am afraid it...
As stated in my previous thread about my blank slate for upholstery, I also have a pretty blank slate as far as the power plant goes. My 1989 Four Winns Freedom 190 Project came with a 4.3L OMC Cobra rated at 175 HP. The block, intake manifold, and 1 head is cracked. So theoretically I have a...
I am about to start refurbing my Four Winns single axle trailer. I know this has probably been asked alot, and not to run the risk of replying to "old" posts, I will ask again. Is it a good investment to replace the current old standard grease hubs with the new oil bath hubs, or is using Bearing...
I picked up a 1989 Four Winns Freedom 190 "Project" relatively inexpensive. But of course this comes with a lot of problems. Most of the interior upholstery was missing and by most I mean all the original pieces. All that was left was 2 aftermarket Lounge seats. My question is, how do I replace...
