Hi Jerry,
The thing is, I do not have a mercury motor the size for the spanner wrench that would be needed to remove the retaining ring or nut for the bearing carrier on the force 150. But I have noticed that it is very hard if not impossible to find The part number FT11275 spanner wrench for...
Hello, could anybody tell me if the Mercury spanner wrench for removing the gear case bearing carrier would also work on the 1992 force 150 hp outboard? If so, what size or part number is it for that tool? Thank you!
Hello everyone, I was wondering if anyone could help me troubleshoot my 1971 6 hp Johnson outboard. It starts with one or two pulls and runs Great for a while at low speed and Full throttle, but after trolling for a while it acts like it's running out of gas or over choked. Any help would be...
Hello to everyone,
The tachometer on my 92 force 150 hp quit working and I was wondering what are some things to check that could cause that? Any help is greatly appreciated!
Well, great news, I found the problem. I had turned the shift cable clamp upside down, and fastened it up that way, and it was jamming up, preventing the shifter to move to the forward position. After correcting that it shifts nice and smooth now!
Yes, it shifts into both forward and reverse. I was able to get some help from my wife and when she worked the remote control, I was back at the motor and noticed that the interlock lever seem to block the movement of the tower year to keep it from rotating in order to accelerate. When going in...
Hello everyone, thanks for all the help you’ve given me in the past with my 150 hp force outboard. Last fall I had the misfortune of fishing line getting wound around the prop shaft behind the propeller that took out the seals and lost all gear grease. When they went to drain the old grease and...
Thanks , I would like to replace the seals but I have never done that before. I’ll have to look into that. Does anyone know if there is a good YouTube video on this?
Thanks! I was hoping that they didn’t have to match the original LU, so that is great!
I have another question for you guys though, I pressure tested the replacement lower unit with the oil drained out of the gear case and the gear case held seven psi, but anything over that leaked out of the...
