GOOD NEWS. . . . The PICTURE UPLOAD FUNCTION IS WORKING !!! The tech folks at the parent company have been able to remedy the issue. You can upload pictures once again. Thank you for your patience.
I'm removing the Mac's river runner from my outboard. Only question I have is do you think I would need to seal the holes left by the bolts used to fasten it to the bottom of the skeg? Or would they be fine just left as is
I have a 1997 mariner 25 2 stroke that will spin just fine, but will not crank. It did this a couple of weeks ago so I took it to the shop. But when they took it back to take a look, it fired right up for them. They then went thru and checked everything just to ensure they squeezed every penny...
In the market for a new stainless prop for my 1997 2 stroke mariner. Does anyone have any suggestions on hat pitch I should use? The motor is mounted on a 1546 g3 Allweld flat bottom. Im looking for a balance between low end pick up and top end, WOT speed
