Current visitors

Home
Members

Bondo's latest activity

Bondo reacted to badrano's post in the thread High Fuel Pressure with Like.

Finally got everything cleaned up and put back together, pulled a new vacuum line down to the regulator just for the sake of having a...

Aug 29, 2025
Bondo reacted to Scott06's post in the thread Lower unit oil leak through weep hole after impeller replacement with Like.

Would think the hot running is what lead to the shutters falling off, usually when water flow is impeded everything on the exhaust cooks off

Aug 29, 2025
Bondo replied to the thread Shift cable bellows..

Ayuh,....... Even if you didn't touch the lower shift shaft, it moved into neutral, or beyond, just by the nature of the...

Aug 29, 2025
Bondo reacted to nola mike's post in the thread Shift cable bellows. with Like.

Still don't think you're getting it. You need to have tension on the prop and lower shift shaft AS YOU REASSEMBLE. Let's make it simple...

Aug 29, 2025
Bondo reacted to Scott Danforth's post in the thread Cobalt 226…Adding underwater exhaust with Like.

easiest way is to add turn down tips.

Aug 29, 2025
Bondo reacted to nola mike's post in the thread Shift cable bellows. with Like.

But are they mated correctly? They both need to be in the same gear when mated, which is why the prop needs to be locked.

Aug 29, 2025
Bondo reacted to mr300z87's post in the thread Milky oil from oil cooler failure with Like.

Quick update. Did 5 quick oil changes with 4 quarts each time and dumping the oil filter, 5-10 runs. The I did a full oil change and...

Aug 28, 2025
Bondo reacted to nola mike's post in the thread Shift cable bellows. with Like.

Not sure if we're all just misunderstanding or you are, but if the lower is not in forward gear but the upper is (ie the shaft is facing...

Aug 28, 2025
Bondo replied to the thread Shift cable bellows..

Ayuh,...... You need to hold the lower in forward, when you slide it into the upper,....

Aug 27, 2025
Bondo reacted to nola mike's post in the thread Shift cable bellows. with Like.

Yes, but it should still lock in one direction at least. I'd take the whole drive off, and if it isn't shifting correctly then, split...

Aug 27, 2025
Bondo replied to the thread Flywheel housing for 280 outdrive and newer 5.7.

Ayuh,..... Welcome Aboard,...... Hopefully, the block of yer new motor is drilled for both the staggered bolt pattern starter...

Aug 27, 2025
Bondo reacted to Scott Danforth's post in the thread Flywheel housing for 280 outdrive and newer 5.7 with Like.

get the smaller 153 tooth flywheel for it. there are no AQ series PDS housings for the 168 tooth flywheel I am running a 153 tooth SFI...

Aug 27, 2025
Bondo reacted to Scott06's post in the thread Boat had been stored for 19 years with Like.

Some good thoughts on the motor above. take plugs out try to turn it over you may get lucky. I have had engines sit for years and turn...

Aug 27, 2025
Bondo reacted to nola mike's post in the thread How would a compromised bellows sink the boat? with Like.

at least on the mercs there's a relief hole or something on the transom shield. first hand knowledge that it can absolutely fill the...

Aug 25, 2025
Bondo replied to the thread Does my GL-5 75W90 need to be official?.

Ayuh,....... That's what I use,... full-synoil......

Aug 25, 2025

Show older items

Home
Members

Top