Can these be bought somewhere? they are not in any parts lists that i have found. I am figuring at this point i am going to just need to pick up 2 carbs with good main jets.
I am trying to figure out where all the wiring goes and i am at a lose. I am looking for where the grounds connect mostly i think i have everything else figured out.
I am trying to mount the seats in my boat and i was going to use 7" pedistals because they seamed a good height. After sitting on them before mount i really think I am sitting way to high. Is there anything shorter than that maybe rails or something that was used back them? I am at a lose on...
I am having a hell of time getting the exhaust bellow to stay on. I have heard of a few people using the Bravo exhaust bellow instead because it only mounts on one side. I have a 3.0 LX engine in the boat. Can some explain to me why I cannot or can use it.
I have access to free leaded fuel, around 110 octane with no ethanol. my friend used it in his banshee and worked nice. I am looking at doing this for performance. It is free and want to use it. so what is the good/ bad/ ugly about using it.
I need the wiring schematic for the 1996 Merc 3.0 LX motor. there are a few connectors that are not connected and i want to make sure that is right. Also having a short issue somewhere and want to do a quick run through. if someone can scan and email to REMOVED or point me a link that would be...
My friend bought a bought and the bellow on the shift cable was bad so we decided to replace all 3. The problem we are having is that we can not get the exhaust and big bellow to stay on. Does anyone know of a video or manual online that i could use to reinstall the bellows.
I searched here and did not find too much information on this. I found information about sealing the holes but not much else. I figure I would use the largest bolts that fit which is 1/2 bolts. Should I put a renforcing plate on the transom and go through that or just go through the would and...
I bought this motor a couple of days ago and the front of the motor was taken off and i have a box of parts. I can figure out where most go but can some take pictures of an assembled powerhead. maybe 10 in a circle where things bolt on. I have a shop manual coming but want to keep ordering the...
What does a Top end rebuild of a 1986 Johnson 40hp with VRO?
I got this motor for $100 and was told it needs a top end rebuild. I am sure it will need more than that but for the price i could not let it go. it is super clean.
I bought this bought back in April and have gone a little nuts getting it back together. All I have left is mounting the seats. I am trying to find pedestals that are adjust and have 9 or 10 inch low height and 15-17 top height. below is a link to my facebook page with the pictures...
I have a 15hp evinrude that i have been trying to get running. I have rebuilt the carb new fuel pump, the needle valve is the one that was on it when i got it. Is the tip of the needle valve come to a point or is flat. It looks like the one that is in there might be broken. It is the only thing...
I picked this motor up cheap and like anything else that is cheap things never run right. I pulled the lower unit off and it had salt build up by the shift shaft. I did not feel like cleaning right now so i got another lower unit off of ebay. It is a 1992 lower unit. With that unit off it will...
Looking through all my options for my boat and home built might be the best way to go. Anyone on here gone through it in NJ. How difficult was it and and suggestions. If you have not done it in NJ please refrain from posting every state is different and I explored most other options.
