I was told the tilt and trim pump that is mounted on the inside of the transom is the problem. The dealer said they were about $1200. Can I get a kit and rebuild the pump? I can't pay that much.
I just finished laminating in my new transom. Now I need to cut the outdrive opening. I'm thinking about just using a sawzall. Anything I need to be looking for. I know at the top I'll have to use a file or something to widen it for the steering arm, but I thought I would post this and see if...
I just pulled my motor and outdrive. On the bottom right corner of the cutout on the transom, by the lowest bolt whole I have rot. The transom seems to be made of two pieces of plywood, the piece on the inside around the bolt whole is only about 1 to 2 inches of rot. The piece back behind it I...
:blue:
I noticed last year my gamble bearing had water in it and I replaced it and put on a new bellow. Towards the end of the year I noticed I was still getting water inside the boat. I pulled the outdrive did not see water in the gamble bearing. I think it's in the transom seal. I grabbed the...
I have been getting water in the boat not a lot but when I would pull it out of the water it has more than it should. I checked the gimbal bellow and it had water in it. I have ordered a new gimbal bearing, bellow and a linement tool. The u joints had a little surface rust but feel like the are...
