When engine is running there is a considerable amount of water spraying from the flange where to the two pieces bolt together. I assume I have a leaking seal but top or bottom of bearing case?
My 1995 65 HP Jet Evinrude is leaking water out the seam where the lower unit bolts on. Should there be a gasket or sealed up so all the water goes out the nozzle?
Has anyone heard of a Jason or a Munch small outboard motor? Found a couple in a barn and really can't read the names real well but I think that is what they said. The Munch I think is a 4 stroke.
I think the foam under the floor is water logged on my 1995 OMC Roughneck 1768AW. I weighed the boat and trailer the other day and it weighs 2880 lbs. I think that is way to much. Is there anyway to dry it out or do I need to completely remove the aluminum deck and replace the foam? What...
Been working on this problem for several months. My motor (1115422AY) seems to have an intermittent miss from idle up to around 2000 rpms. Even had it miss at 5000 rpms occasionally. Seems worse in the mornings when it is cold. Once warmed up it seems better. Pulled the plugs to see which...
My motor has started missing at low RPM's recently. I thought fouled plugs and changed them but it didn't completely eliminate the issue. These models are the ones that only use two cylinders under a certain RPM and then kick the other two in when throttling up. It seems once I get the boat...
I've been told that for higher elevations there is a different carb set up for these motors. I use my boat around 4350' elevation. Are there different carb jets that can be installed in my existing carb? How do I tell if it needs the different carbs/jets. Doggy performance, higher fuel...
It is a 90 hp crossflow powerhead. It gets de rated to 65 hp by adding the jet drive. See the 65 hp engine cover. I never thought of the foam saturated. I guess I should weigh the entire set up too. My original question was, can I add the exhaust, carbs for a 115 powerhead on my 90 hp power...
I need a little more HP for my jet boat and want to know if I can gain some HP on my 1995 E90jelor by adding some 115 parts? Exhaust Manifold maybe?????
Id like to check the ignition timing on my 1995 E90JLEOR and the manual says to use a test wheel and not the flushing tool. How can I see if I'm 28deg BTDC at wide open throttle without the test wheel?
How much slack should you see in the control box cable from a 1995 side mount control box? If I have some one hold the main control box lever and I push/pull on the cable where it connects to the throttle I see about an inch of travel without moving the handle. If I go to the other end and...
Guys, before I fire up my rebuild is there a way to verify that I've got water flow through each cylinder? Can I use the flushing port at the bottom of the lower unit, connect garden hose and then remove each hose from the bottom of each head that goes to the thermostat housing? I should see...
