Please note that the PICTURE UPLOAD function is not working. The iBoats Forum Moderators are working with the system administration folks at the parent company to get the issue resolved. This happened about a year ago and here we are again. In the meantime you can post photos as links to a picture hosting site of your choice. We are sorry about the inconvenience and will advise when the issue is resolved. Thank you for your patience.
When taking some of the old floor out the adjustment came loose on the saw and went through the bottom of the boat I read two layer with fiberglass cloth and resin on the inside but what should I do on the outside before I gel coat it it's just the width of a saw blade about a foot long
How do you remove the colored rivets that hold the plastic covers on the rear corner of my Bayliner Capri boat the one cover has a vent for the air pump the other corner just looks like fresh air in
I'm marrying this down so thank you for all your help it's been great but my question is now I ran into an issue I have a 93 4.3 with the balance shaft it is considered the heavy version I have a motor that by the serial number is 93 through 97 but it has the light balance shaft which would...
I am new to boating so I apologize if this is trivial we are taking our non Vortec engine out of a boat that we bought with a cracked block and replacing it with a newer Vortec engine that we are going to rebuild 2 Marine specs and install my boat is a 1993 and a half according to MerCruiser...