Does anyone have a recommendation for a plywood alternative for non-structural (i.e. interior panels) applications? I'm aware of Penske board. Is there anything else out there? My main goal here would be weight reduction.
Any thoughts or experience with running a QJet on an Edelbrock 2692 Performer Intake with the adapter kit?
My current set up is a 1997 4.3 with a Qjet and Steel Manifold which is working just fine for me.
My biggest reason for looking at the Edelbrock manifold is the weight savings it offers...
I recently converted my Cobra from an 1988 to a 1997 4.3 block. I am running the distributor and 4BBL Carb from my 1988 motor in the 1997 set up now. Any thoughts on where I should set the timing marks? I keep reading 8BTDC for earlier 4.3's and 0-1BTDC for the newer models. I wasn't sure if...
Yes....you read that right.
I was wondering what you guys thought about converting a 1988 2.3 to a 1984 3.8 using a V6 Cobra drive.
Here is the backstory.....I purchased a donor boat with a cracked 1988 4.3 a few weeks back with the intentions of getting a Rapido motor or a donor motor from...
