Im looking to paint new epoxy coated fiberglass in the center bilge area of a bass boat that I just finished replacing the stringers and transom in. Which type of paint is the best for this? Topside, Bilgekote, etc???
Is there any advantage to drilling thru the floor and pouring the foam in or just foaming between stringers before attaching the floor. Seems to me drilling holes in floor is risky due to water possibly getting into the bottom of the plywood floor because wood not being sealed where you drilled...
Crazy question but which side of the Biaxal fabric goes up? Im starting the stringer glassing in two weeks and im just going over the project before i start. Thanks
Im replacing the stringers and transom in a 1993 Tidecraft Wildfire. I have spent the last month reading post from others and have learned more than enough. My question is what type of fiberglass should I use for the stringers? Most post differ on layers and types. The original stringers were...
Im replacing the stringers and transom in a Tidecraft Bass boat and the split line from the top to the bottom hull had rivits holding them together. I believe they were aluminum ( at least they drilled out easily). What kind should I reinstall? Stainless, Monel or aluminum.:confused:
I have an 1978 Johnson 115 and I cannot get the motor to go to full power untill I pump the fuel ball. I have replaced all fuel lines, vent lines and fittings along with installing new coils and powerpack. When at WOT it bogs untill I pump the ball (which is hard already) then it picks up untill...
