Recent content by carlosburitica

  1. C

    Float height adjustment on 1985 Force 125

    I need to know the carburetor float height adjustment For 1985 4 cylinder 125hp Need to know the float height and drop values Thank you
  2. C

    125 force counter rotation?

    Is there a lower unit with counter rotation for a 1985 125 force to use it on a twin engine setup?
  3. C

    1984 125hp carb help

    I got a an 1984 125hp force outboard model 1251x5a Motor runs good for a wile but then it bogs and cant run at low idle speed. So I removed the carbs and found that one has a needle missing so that is why the carb was flooding and making the engine stall at low rpms As you can se on the pic...
  4. C

    125hp force 1984 prop help

    I recently got a 1984 bayliner 2110. It came with a 125hp force and need to replace the prop that is damaged. According to the seller this was the original prop that came with the boat. This is what I can read on the prop This is what the engine says. And found this info...
  5. C

    Prop for 1984 125hp force

    I recently got a 1984 bayliner 2110. It came with a 125hp force and need to replace the prop that is damaged. According to the seller this was the original prop that came with the boat. This is what I can read on the prop This is what the engine says. And found this info...
  6. C

    new battery installation goes bad on 96 evinrude 150

    sounds odd but one of my batteries went bad so i decied to purchase to new ones, intellad them and went fishing.... started the engines nice and after 30 minutes in my first stop with engine off i see smoke coming out of the engine, literaly about to get on fire, so had to use my fire...
  7. C

    1996 evinrude 150 premix question

    after testing my oil pump i decided to go premix. i did the conversion allready but: what is the oil ratio i shoud run in this engine is 50:1 the right mix ratio
  8. C

    ingnition alarm beeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeep

    never saw this before. i have a 150 envinride v6 1998. as sson as i put the key in the ignition swith a long beeeeeeeeeeeeeepp comes in. but after i start the engine it goes out. oil tank is full, i can't be overheat since it is doing it at cold start. any inputs or were to start to diagnose?
  9. C

    150 ocean pro working on e cylenders only

    so i have an evinrude 150 1994 ocean pro that i just got, when it got it it ran fine out the water, took it for a test drive and idled fine for couple miles, got out the inlet an at wot berelly got 25mph i figured old gas, cloged filter and carbs, cloged fuel vent. got home a removed fuel and...
  10. C

    whant to go premix

    hi i just got a 1996 150h evinrude ocean pro outboard and whant to go premix, i had many two stroke jet skis to date and always did. i usially get an oil pump blockoff plate and that is it. looks to me two stroke outboard are little diferent than all the two stokes i korked before. to make a...
See more
Top