Recent content by carsonmajure

  1. C

    94’ 15hp

    That’s what I was thinking, but hear me out on this. #1 The boat ran great for about half mile at WOT and then started having the issue and I had to idle back to the ramp. If the transom height was the issue, wouldn’t it start revving up/cavitating/ventilating immediately? #2 The cavitation...
  2. C

    94’ 15hp

    I did that, it ain’t spinning
  3. C

    94’ 15hp

    The splines inside the prop and on the proppeler shaft itself are undamaged. The new hub was hammered in, it’s a small rubber fitting that goes inside the prop with 3 grooves that fit in the prop.
  4. C

    94’ 15hp

    It’s a short shaft. I used this motor on my Jon boat all season and it worked great. However, this boat is a new boat I rebuilt its fiberglass but still the same dimensions 14x4ft. The transom is a tad bit taller, but the cavitation plate still sits about 1-2 inches below the bottom of the hull...
  5. C

    94’ 15hp

    I have a 1995 Mariner/Mercury 15 hp that is having symptoms of a bad prop hub, but I replaced it and it’s still doing it and the hub is in perfect condition. The motor will work for a little then begin to slip and rev up and lose traction. I can drive slightly above idle but as soon as I give...
See more
Top