I have a 88 Bayliner 1950 with a 3.0L Chevy engine and OMC Cobra sterndrive. The plug that is opposite the OMC Cobra medaillion fell off. I now have a quarter size hole on the side of the upper housing that water escapes from when running. This also causes the engine to overheat. It only...
Could someone please advise on the best prop size (diameter & pitch) to get for my 88 Bayliner 19' with a OMC 3.0 I/O GM engine. I have a family of 5 and spend much of my time pulling a tube or skiing.
I want to install a trim gauge on my 88 Bayliner 3.0 I/O. I bought the boat used and there was a trim gauge in a box but not installed. When I installed it the gauge would move all the way to trim up regardless of where the lower unit was. I checked the wiring and matched to the directions...
I have a 99 bayliner with OMC 3.0 4 cylinder GM engine. Does anyone know where the oil pressure should run. My oil pressure gauge registers about a 20 reading at idle then moves up to about 40 at 2000 rpm and stays there. The gauge goes up to 80. Are the gauges just not that accurate to begin...
I have a 88 Bayliner 1950 bowrider with the Chevy 3.0 140 hp engine. I launched the boat and lowered unit into the water using the tilt switch to warm up the engine. When I tried to lower it to the running position the unit was dead. I opened the manual release to lower the unit to use the...
