Recent content by classic20

  1. C

    2004 yami 150 tach light

    how do i wire the tach so it will light with the rest of my engine instraments?
  2. C

    primer bulb location?

    I just installed a new yamaha 150. Due to all wiring and hose routing through one opening on the motor and then through the large rigging hose the primer bulb ends up in the underside of the floor. I don't like this for fear the bulb should leak. Does anyone have any suggestions.
  3. C

    primer bulb location?

    I just installed a new yamaha 150. Due to all wiring and hose routing through one opening on the motor and then through the large rigging hose the primer bulb ends up in the underside of the floor. I don't like this for fear the bulb should leak. Does anyone have any suggestions.
  4. C

    2004 150 volt meter

    I have a 2004 yahama 150 2 stroke carb model. I want to add a volt meter. where can i pick up the signal to wire the volt meter.
  5. C

    engine weight

    can anyone tell me the weight of 1986 140, 20 inch shaft.
  6. C

    need owners manual

    Can anyone tell me where i can find and owners manual for a 2004 150 yahama?
  7. C

    brand new yamaha 150

    I just bought a brand new 2004 150. It is the carb model. i will be installing it next week. just was wondering if any had any tips or things to look out for? Also is there anything special that should be done before the first start up?
  8. C

    saltwater series ?

    did yamaha do away with the saltwater series for 2004. Did they also do away with the EFI 150 for 2004. From what i can tell on there web site there is only four choices. Four stroke, hpdi, vmax, and i'm guessing but it seems to be a carb model. can some one explain.
  9. C

    shift lever problem

    I have 86 140 evinrude. the shifting has been very stiff. I opened the shift lever housing, and found parts to be chaffing on the case. there is a large spring on the lever shaft that may have lost some sring. also i was wondering if there are parts missing. Is there somewhere i can find a...
  10. C

    15 hp no spark

    i have a 86 15hp. the motor sat for about a year. last time it was run it ran good. i went to start the motor recently and found it to have no spark. how do i best determine the faulty ignition component without buying all new parts. it is a 2 cyclinder, both don't have spark.
  11. C

    looper crossflow ?

    can someone tell me about loop charged and cross flow and what the difference is. is one better than the other. also how do i know which system my motor has. i have a 86' 140
  12. C

    head temp

    i have 86' evinrude 140. what should the head temp be. i read 123 to 125 running. at idle i can't say gauge only goes down to 120.
  13. C

    TEMP SENSOR LOCATION

    can anyone tell me were the best location is for the water temp sensor to be located. my temp gauge is reading incorrect to low. i beleive the sensor is not positoned properly in relation to the water jacket. i have an 86' 140 evinrude. motor runs fine gauge reads worng.
  14. C

    140 water temp

    i just bought a used boat, it has a 86' evinrude 140. the first time out the water temp at idle was 163 running was 200. this is too high according to the book. i replaced the temp sensor. now the temp won't get over 125 running. i'm wondering about the placement of the sensor, since it just...
See more
Top