i have a 84 evinrude 115.ill start with the vro pump first, the boat sat for about a month today i pumped prime ball geting ready to start motor i saw gas flowing out around the vro pump seal. should it be replaced or rebuilt and would it cause the motor to run different.when it was in the water...
i found it once before .there is a website thats free where it will give you the schematic of the motor.parts prices etc all u need is the motor mod
.anyone know the site address
i have a 115 84 evinrude. was cleaning my carbs with seafoam everything i was told to do worked . when i sprayed the carbs the motor started to putter and even stall which is normal.my friend has the same motor when he sprayed his carbs nothing would happen the motor would not change how it was...
i replaced the impeller waterpump and thermos, just put the muffs on and it peeing just fine the water was net even warm but the heads were hot could only hold my finger there for about 3to4 secs .i can also run all day with no alarm going off untill i go wot.deflectors??????
i have a 84 115 evinrude . replacing the thermos for one didnt have any ? got the kit my question is when i put it back together it says when you put the thermos in you put a round gasket over the top of them and then the valve body gasket when you do that the valve body gasket sits a hair on...
i have a few posts up but i got a repair book today started to reed through it and it says to gap my plugs @ .40 not .30 :confused: my motor has also started to bog out then in at full throttle i just looked @ the starter solenoid loc above the carbs has a red valve switch on it. there is some...
i have a few posts up ,but need some help on this .84 115 evinrude .how much should the butterflies open up in reverse? if i adjust the cable it open up alil bit in reverse and all the way in foward but when i start the motor its at to high of a idle. so if i adjust the cable again the motor is...
just replace the cables and throttle bar.. put the boat in full throttle looke at the buterflies opened up about 3/4 put the throttle in reverse butterflies did not evenopen .. is there something i can do with the throttle ,some part that may need to be replaced ? i have about 3" of play before...
i have a 115 84 evinrude it has a vro pump i mix the gas and oil myself 50:1 my question is can i buy just a fuel pump without vro. i think it may be bad.
ok i have a 84 evinrude 115 . new impeller new thermostats just put in . took the boat out today @ full throttle the over heat alarm came on ? why? also the motor runs great at 20mph no prob. when i go full throttle the motor starts to spit an sputter revs up then down then up .when i go back to...
do i need to buy the special rollers to apply the paint? It said they are for the texture i looked at lowes there was something almost the same for half the price..........
