Recent content by cpdad93

  1. C

    Mueller boat hill repIr

    Yes it seems to be two fairly thin layers of fiberglass, with a piece of foam sandwiched between them
  2. C

    Mueller boat hill repIr

    No idea, all I have is the tag on the back and what be a model number of 13199
  3. C

    Mueller boat hill repIr

    Anybody done one? Thanks
  4. C

    Mercruiser 120/140

    I have an 87 Larsen 120 mercruiser ( the wife’s fishing boat). The 120 is froze up. Is the 140 a direct swap as I did find one of those. A mechanic told me even other 2.5s may not be a direct swap as there are multiple bolt patterns on the 2.5. TIA, Don
  5. C

    1987 Larson 120 motor removal

    How heavy is that drive?
  6. C

    1987 Larson 120 motor removal

    Happy fourth to all. I have an old Larson with the 120hp in it. 2.5 GM I believe. Previous owner ran it out of oil so it is seized up. In wanting to pull the motor it says to remove the out drive. Can I not pull the motor out with the out drive left in? Thanks, Don
  7. C

    stackable boat storage

    I am not really cheaping out, just trying to avoid some big holes in my new 28x32 epoxy floor
  8. C

    stackable boat storage

    Has anyone made a homemade lift? I have a 1959 chris craft that I want to stack my raysoncraft on top of for the winter. I have had all kinds of crazy ideas starting with 4 posts.. One with electric winches and then a cross bar once its up, another with toothed track and four motors, and a...
  9. C

    1987 120 (2.5) bolt pattern

    I have an 87 larson runabout with a froze motor. Previous owner ran it out of oil. In looking for a replalcement block to rebuild, apparently gm has four patterns of these. Is there a list to figure out which one I have? I found a rebuilder out of an 88 s10 with a bad head, but it is 170...
  10. C

    Breaker bar rotating 2.5

    Is there a way to get a service manual that doesn’t cost a gold tooth?
  11. C

    Breaker bar rotating 2.5

    I bought an 87 Larson with a seized 2.5. I wanted to see if I could free it up prior to removing it. There doesn’t seem to be a good way to get a wrench on it. Any help would be appreciated. Thanks, Don
  12. C

    OMC tilt

    I am sure this has been addressed but I can't find it...Like many OMCs my tilt clutch assembly was full of water..motor works fine, the clutch pack is out but since I was in there I wanted to replace the seals on the outdrive side and add a drain plug. I removed the snap ring but can seem to...
See more
Top