guys,
I just dont understand. I just cleaned the carb out. float was missing needle, so i replaced it. now i can keep it running only if i pump the carb full of gas and then disconnect hose!!! and then i have to hold the throttle in the start position plus hold this other piece wide open and i...
guys,
I just dont understand. I just cleaned the carb out. float was missing needle, so i replaced it. now i can keep it running only if i pump the carb full of gas and then disconnect hose!!! and then i have to hold the throttle in the start position plus hold this other piece wide open and i...
ok i recently had posted a question and i think i have fixed that problem not sure quite yet. have not tried the motor yet. i figured i would go ahead and switch the coil ignition. but i can not get the magneto off. i have read some things i can try and see if that is how i do it but info on...
I have a 1986 gamefisher outboard motor 5.0. I have very little knowledge of motors let alone boat motors!! If i tilt the motor, gas leaks out like crazy. We put new plug in it and shot some starter fluid into it. we could get it to run for like 3 to 5 secs. tops. whats going on here guys.?? i...
