Here is the info sheet I downloaded referencing the new tool numbers in regards to the specific motors. Someone told me to use Collar #328363 & Gauge #328366, but I now see that this is not correct for my motor. I have an '85 Evinrude 50HP, long shaft (E50BELCOB). If Im reading this sheet...
Thanks Sean.
I have the second set of tools that I've listed. I've set them up and gauge the tolerances. However, (Pardon the pun) the shaft seems a bit long, maybe 1/8" inch. The tool for the Short 15" shaft model is a perfect fit with ZERO clearance... To hense my doubt. (I have the Long...
Thank you for the input. I have the shimming tools and more confidence than experience, so that makes me somewhat dangerous. I'll call my local shop today, but since I'm in Arizona, I have my doubts as to the experience of a shop that doesn't see a lot of Evinrudes.
I have an E50BELCOB, 1985 50hp that I am rebuilding the lower unit on. Everything is apart and ready for assembly, but I'm having a difficult time with the shimming specifications. The service manual calls for OMC special shimming tool #320739, which I cannot find ANYWHERE. However, I've been...
