Re: 14 ft mckee (shallow water fishing)
This boat does have some trim tabs like the ones shown here and does get on plane rather quickly if I am in deep water, otherwise it does squat quite a bit causing the prop to hit bottom. I have noticed that this boat floats in about a foot of water. I...
I was hoping someone from this group could help me out. I have this 14 ft mckee craft that my wife and I enjoy using for fishing in the Intracoastal waterway near corpus christi. I have had this boat for a few months now and have noticed that it runs well and is a blast to run and fish off of...
I would like to get some insight from the members of this group. I have a 1995 johnson 48 spl that I just purchased. this motor runs great when I let it idle and can even accelerate it with the muffs on. the first time I put it in the water it ran great through the no wake zone at a slow...
Hopefully the members of this group can give me your thoughts on a boat that I just purchased. It is a 14ft Mckee craft boat that is in pretty good condition. This boat will predominantly be used by my wife and I. Considering that this boat is almost a clean slate, I would like to get your...
I need some input from the members of this forum. I am thinking about purchasing a glastron 1980 tri-hull to be used mainly in the laguna madre in Texas. This boat is 14 ft tri-hull and will be used mainly to go about 2-3 miles top in either direction from the ramp. I will be having to use...
Re: dodge dakota pulling question
thx. The truck is 2wd. Not sure what the boat weighs but I figure it could not weigh much since it is a 14ft boat. Here is the picture of the boat. It is 1980 model.
I hope you all can help me out here. I am thinking about purchasing a 1980 14ft glasstron tri-hull. I would like to know your opinions if a 2001 doge dakota will pull this boat without any issues. It does have the towing package and has a 3.9 v6. . My concern would be at the ramp. Any...
