Can anyone confirm the torque specs for the block halves on a '94 Force 70? I'm hoping my pistons and rings show up today, and I'd like to throw it all back together. The outer block half bolts are the only ones I don't have the specs for, and a search hasn't yielded any results other than this...
Re: 1994 Force 70 - powerhead removal
The plate on my toon says it's rated for up to a 125, so I could go bigger if I found a motor.
I need to decide what I wanna do. When pulling the flywheel, the bolts pulled out of the threads, so I had to knock it off with a hammer. That broke the magnets...
I know I should buy a manual for this thing, but I'd like to snatch the powerhead off right now, and not have to wait for a manual to get here. Not to mention I'm not sure at this point that I even want to invest much more in this motor. I've had prop shaft issues which I'll start a new thread...
Re: 1994 70hp force water in #2, good compression.
Any chance your piston looks similar to this pic? My motor has been skipping, so I took the head off yesterday and found this after doing a compression check.... Once I figure out how to get the powerhead off, I'm gonna try replacing the...
I was trying to disassemble my lower unit today to remove the prop shaft. I mistakenly thought everything under the water pump had to come out. I ended up breaking the tabs off of the water pump base. At least I think that's what it's called.... Anyways, after looking online for a replacement...
I recently bought an older pontoon with a 70 horse Force on it. The boat had been sitting for awhile and ran a bit rough the first time out, mostly not wanting to idle well. I could also see a bit of oil on the side of the motor under the cowl. I replaced all fuel lines, cleaned the carb, and...
Tried searching but couldn't find the answer.....
I have a new to me boat. 88 model, mercruiser 5.0 and alpha one drive. Shift interrupt switch isn't being triggered. Seems the cables have too much slop to trigger it? I've tried adjusting them from directions I've found on the net, to no avail...
