Recent content by cup of Joe

  1. C

    MerCruiser 7.4L Bravo GM 454 V-8 1988-1991 Oil Filter & Adapter with two filters

    Don't be confused, have a seat and relax, Count to ten, take a deep breath, and let it go. I am mounting the wix oil filter on my transom, and I can mount it where ever I want. Remember my transom will be very close to the front of engine .
  2. C

    MerCruiser 7.4L Bravo GM 454 V-8 1988-1991 Oil Filter & Adapter with two filters

    For the ones that were confused, I have this MerCruiser 7.4L Bravo GM 454 V-8 1988-1991 Oil Filter & Adapter system on A 1990 MerCruiser 454 BBC engine I am getting ready to install in my 1971 Day Cruiser. Normally this system is installed on a Engine as this parts diagram shows. This 454...
  3. C

    72C Velvet Drive

    Thanks, my 10-18-014 does not need to be rebuilt,, All I need to know what goes on the output shaft. This 72C came with my V-drive boat as extra parts. I was going to install it, but it seems I can not find anyone that would come up with the knowledge of what is missing. I have it on Craigslist...
  4. C

    MerCruiser 7.4L Bravo GM 454 V-8 1988-1991 Oil Filter & Adapter with two filters

    I have a Remote oil Filter Adapter with two filters. Does the system need two oil filters??? I shared this with Patrick in marineengines.com he could not find a cover either. This system is for MerCruiser 7.4L Bravo GM 454 V-8 1988-1991 Oil Filter & Adapter, 0B771113 - 0D603117. the large WIX...
  5. C

    72C Velvet Drive

    Looking for a 72C Velvet drive, 10-18-014 for a MerCruiser?
  6. C

    exhaust - Resolved

    , Have Nice day. I use the potatoes Thank you
  7. C

    exhaust - Resolved

    Thanks any way for all you guys help.
  8. C

    exhaust - Resolved

    I did run water threw it and it is not blocked.
  9. C

    exhaust - Resolved

    resolved Hello , I just R&R my exhaust manifolds and noticed only one side had a exhaust flapper. 1986 OMC 4.3 stringer I have heard they have been discontinued to use on newer models. My 1972 threw the transom V-Drive Stevens flat bottom Did not have any flappers, never was a problem. So if...
  10. C

    1985 OMC stringer 800 with a 4.3 possible cracked engine block

    Thank you all for your help. Finally after 3 days of snow I got to uncover the project. I found out Where the water got into my 1985 4.3 OMC STRINGER. I found the fuel pump gasket upside down causing the engine to let water into the engine when I steam cleaned the bulge area and engine. Engine...
  11. C

    1995 Larson 214 LXI... Floor and stringers

    Your project is looking great. Those stringers and bulkheads take a lot of layers. I removed the top off of the hull, this was my 1989 Rienell
  12. C

    Worst snowfall on record in U.K.

    So You guys got all the snow this winter. Here in Lake Tahoe CA/NV we Finally got a good snow storm for this winter, Kinda late but we got about five feet in a few days. and more to come I hope. The more snow the more revenue and more water in the lakes. Stay warm,
  13. C

    Is foam enough?

    Wow that reminds me of my 1989 Reinell, It had all the wood rotten, It was a bad year for reinell's The stringers, transom, motor mounts, all rotten wood. A sawsall and grinder were my tools, and a painter suit duck taped around my wrist and ankles , gloves full face mask. And make sure you have...
  14. C

    Omc stringer vs cobra exhaust manifolds

    Thanks Lou, Yep That's how I did it . Plus I plugged the exhaust out let and the water out let so the acetone could fill to the top.
Top