I pulled apart my rochester 2bbl carb and am cleaning it up. Anyone know what the exact float drop is so I can check that also? It goes on a mercruiser 120 hp motor.
I have a mercruiser 120 hp 1986 motor with a rochester 2bbl carb on it. I recently purchased the boat and the guy I bought it from said it had a hesitation to it when accelerating. I took it out the other day and sure enough you could barely get on the throttle without it trying to go dead. He...
I know I have asked before but just want to check before I buy smarttabs. I bought a glasstream 15 feet 120 hp mercruiser inboard boat. When i get on plane the front of the boat starts bouncing so bad that it feels like I am gonna start flying and I have to come to a stop to get it to quit. I...
I have a 1987 avanti boat with a 120 hp mercruiser motor on it. I recently remodeled the interior vynil and while taking it apart I removed the wood with the throttle lever. I had to completly disassemble it and now I dont know how the wires feed through that go back to the trailer trim and trim...
I am looking a buying a 16 feet 120 hp mercruiser glasstream ski boat. The motor was gone through and had a cracked head replaced a year ago and hasnt been run much since. Took it out for a test drive and everything good except light bow which i discussed in an earlier thread. But my question is...
Hey I am looking at another boat to purchase. It is a Glasstream 16 feet ski boat with a 120 mercruiser inboard motor. It drives very good except when you get going fast it starts bouncing in the front end unless you put weight up there. Any ideas on what that is or is it just the way the boat is?
Hey I bought an Avanti 17 feet 1987 ski boat with a 120 mercruiser last fall. Well I have had some major tipping problems with it when I take it out for cruising. When I accelerate soemtimes it will almost tip over to whatever side the most weight is on. My friend said he has never seen one do...
I just bought a used avanti 1985 17 feet ski boat with a 120 hp mercruiser motor and an 18 pitch stainless prop. My question is when i take off with the trim down and start going up the boat sometimes goes dangerously close to tipping over on one side. Maybe I am just not experinced enough or is...
