Recent content by Dbobjack

  1. D

    Cornfused

    I get no fire on #2 cyl, stator is new dva is 250v,trigger is showing 1.3v at crank speed,pp is showing 180 v at all 3 coils,coils are good moved them around wires have good cont. If there is 250v going into pp shouldn't there be 250v coming out and if SCR on #2 is bad would it read any dva at...
  2. D

    Cadet

    Would sudden spike on stator ohm test indicate problem,this is on 77 Johnson 70 hp ohms went from approx 650 to 1050 with stator unhooked from pp dva is around 350 when hooked to pp dva is unreadable, flashing. I was going to put new pp on but stator scared me away,,,any ideas
  3. D

    77 Jonny 70hp

    No fire on #2,coil is ok i switched trigger wires 1 to2 and 2to1 2 will fire 1 so I think that should eliminate trigger as the problem #1 trigger wire would not fire #2 I am guessing new power pak is not good no fire on 2 since it was installed anything else to check?
See more
Top