I want to install a trim gauge on my 1997 50hp Evinrude. Does this require a sending unit or do I just need the gauge? If I need a sending unit, does anyone know how much it might cost?<br /><br />Thanks !
I have a 1997 Evinrude 50hp. Can any of you guys give me the part # for the trim/tilt gauge? I'm looking to purchase one off of ebay and there are several different part numbers to choose from.<br /><br />Thanks !
Does anyone know any good sources to contact for a used tilt & trim?<br /><br />I have a 1997 Evinrude 50 SPL with the old trim assist that is not working and would like to replace it with an oem tilt/trim.<br /><br />Thanks !
I'm going to replace the oil hose in a few weeks because it appears to be the original and I noticed signs of cracking.<br /><br />What type and size of hose should I buy?
Guys,<br /><br />The gas assist cylinder went out on my motor and I have located a used one at a local salvage yard. <br /><br />Before I buy it,...<br /><br />How hard is it to replace the cylinder on this outboard?
I have a 1997 50hp VRO with System Check. When I turn the key on I hear a beep followed by the lights on the tach turning on and off. Is this beep supposed to be the warning horn?
To test the no oil warning system, my OMC Service Manual states, "Carefully, cut the oil supply hose from the pump oil inlet fitting." My engine is an 1997 Evinrude 50hp.<br /><br />Where is the inlet fitting they are talking about?
I just bought a System Check tach on ebay to replace my old one on my 1997 Evinrude 50hp. The new tach states on the back "For use on 5-6 pul/rev alternator equipped outboards". <br /><br />Will this work with my outboard?
On the right side of my motor there is a shrader valve (with cap) and also what looks like a red pointer. What is the function of the valve and pointer?<br /><br />Thanks !
