Can you guys please help I have these 4 fault codes:
94 Pitot Pressure Boat Speed sensor Low
75 Fuel Level Circuit High
119 Steering Position Circuit Low
130 Trim Sensor Circuit High
Can anyone please direct me in the right direction? I tried to clear them but they say still active. Any help...
Once again I am asking for help For this 1973 135HP. OK here's the story.... When I have the boat in water an it is in gear at full throttle the boat goes only about 10 MPH @ 1900 RPM. The carbs open up all the way. And then if I put it in neutral and use the warm up lever the RPM goes up all...
Can someone please please help me? I have a 1973 135HP Evinrude that smokes way to much. Then it will die out at idle because the plugs foul out. Oil to gas is 50:1 I drained the tank twice to make sure I put 50:1. Compression in all four cyl. is 140-145. New plugs installed, I put new carb kits...
