GOOD NEWS. . . . The PICTURE UPLOAD FUNCTION IS WORKING !!! The tech folks at the parent company have been able to remedy the issue. You can upload pictures once again. Thank you for your patience.
In the photos I am trying to identify the valve located just below the fuel pump (with a red lever on it). I seem to have fuel slowly leaking from it while running. Also, when using the choke during starting, a drop of fuel will shoot out from this location.
I have been told that this is a...
I am replacing the impeller on a 96 Johnson 130 (model J130TXADA). I believe I am ready to go on this, but a bit sure on how to get started. I've read that in order to allow the lower unit to come off the rest of the motor, the shifter needs to be disconnected near the carbs first.
Can someone...
Removing bad steering cable from a 95 Seaswirl Striper 20' center console w/96 Johnson 130 outboard. I cannot get the cable far enough out of the tilt tube for the end to clear it. I can't imagine they designed it so you have to remove the outboard just to replace the cable.
What is the best...
I have a 96 Johnson 130 on a 95 Seaswirl Striper 20' center console. The boat is used in salt and brackish water in and around the Sandy Hook, NJ area.
1. What water separating fuel filter should I go with?
2. Where is the best location to install it on this boat?
The boat is a 95 Seaswirl Striper 20' center console. I put in a new Teleflex NFB steering unit in 2003, but the cable is the original (Teleflex) that came with the boat. If I loosen the nuts at each end of the tilt tube, I can move the whole rod end of the cable freely back and forth thru the...
