Recent content by dtigner

  1. D

    Crankshaft worn ,MEC.Fuel pump won't work..ANY CONVERSION??

    My 1984 MERC. 140 3.0L Ran great up untill the other day when I noticed no fuel was getting to the carb. It uses a Carter LOW Volume mechanical fuel pump . I assume the crank shaft it runs off of is worn out in that area because a new pump won't even work!Any ideas? someone told me to convert it...
  2. D

    How to get AIR out of my hydraulics,goes up but not down!

    I have a 84 3.0 MERC./alpha I I/O and my hydraulics got air in the lines?? The pump works fine if I hold "UP" the unit will go up but if I press "DOWN" Just a little jerk down (like 1") and the pump motor will run and THEN THE THING STARTS TO GO BACK UP!!!( :confused: On the "down"...
  3. D

    Seperating Sterndrive from Bellhousing ,shift cable tool???

    Hi I've been all over my shop manual and I'm tring to seperate the stern drive from the bell housing but it will only come out about a 3/4" and stops dead. Manual says the SHIFT cable is attached to the bell housing and needs a special tool to remove (91-12037)all models it says. Its a alpha I...
  4. D

    Merc. 3.0 water in oil ! ,what are some problem areas??

    I having no luck with another boat I purchaced not to mention I'm NEW to BOATING so laugh if ya need too because I don't have a clue :D ,Its got a 1984 3.0 merc I/O 140 (181 CID) in it and I changed the oil and it looked like a light gray milky color. I know the boat sat for a season...
  5. D

    Trim Limit Switches...wire problems

    NEW to the forum and very interested in what kind of feedback I can get with my problem. I just got a 1984 Four winns 190 Horizon with the merc 3.0 I/O 181 cid,w/ power trim "XD"... Anyway I went and looked on the Transom Assembley and the wires to the trim switches are gone!! ROTTED off?? So I...
Top