Please note that the PICTURE UPLOAD function is not working. The iBoats Forum Moderators are working with the system administration folks at the parent company to get the issue resolved. This happened about a year ago and here we are again. In the meantime you can post photos as links to a picture hosting site of your choice. We are sorry about the inconvenience and will advise when the issue is resolved. Thank you for your patience.
When I replaced the power pack then stator the motor fired up and turned off with the key. What could have happened that now it won't turn off? I can't help but think I knocked something loose.
I ended up blowing the fuse while looking for the black and yellow wire. So I'm on hold until I replace that. Hopefully tomorrow. According to the wire diagram I found, this is my black/yellow wire.
Ok. I have continuity in the red pin connector of the wire harness to the power pack black/yellow. I looked up the wiring diagram. I'm positive I tested the correct one. I don't have continuity between the male and female connectors for the black/yellow wire.
Thank you for you patience with my lack of knowledge. I did the tests. I do not have continuity to the black/yellow connector that goes the the power pack. I disconnected the wire harness and I also do not have continuity from there to the black/yellow wire on the power pack. So based on that...
Thanks again for the advice. I ran the tests.
With the key ON and engine off I get a reading of .01 on the wire harness kill switch (black and yellow wire).
I get no reading from the black and yellow wire on the power pack.
With the engine running, I grounded an insulated probe and...
Sorry for the delayed response. Busy week and haven't has time to touch the motor. I will run the continuity test later today. I appreciate your help. I'll keep you posted.
What if I cut the connectors off both black and yellow wires and spliced the wires together? I took apart the control box and the wires connected to the ignition switch look good. I guess my next step is a new ignition switch.
Not sure what you mean. Every time I turn the motor on, it won't turn off. The power pack is OEM (according to part number for my motor) but the one connector wasn't compatible.
Thanks. I will check that later. I'll post the results. I appreciate
So with the engine running, I clipped the alligator clip from my tester to the black ground on the power pack. I then touched the probe to the black and yellow wire coming from the power pack. The engine shuts off. So I...
