I have a 70's Chrysler boat with an out board engine. I installed a bilge pump in the bilge. When I went to test it, the water just disappears? When I checked it out, I found a hole in the front wall (towards front of boat) of the bilge where it meets the floor (bottom) of bilge. If I keep...
I am trying to replace my manual tilt with a power trim tilt from the same era. It has 4 hoses, 2 cylinders and a pump. I bench tested it already and it is operating fine (picture 1).
I am now trying to install the new power cylinders and I wanted to make sure I am taking the right stuff off...
