2006 johnson 115 2 stroke . It's been going into reverse funny for a while . It's hard to shift and sometimes I have to push it into neutral and back into reverse a couple times to get it to engage ? Now I have none. Havent looked at anything yet to find the problem gonna get into it tonight...
well I think this is a 1980s something 8 horse mariner ,but not sure I think the main plate was popped off any help would be great thanks. and thanks to all for the lessons on how to post pics
1975 johnson 9.9 will run with the choke pulled out half way . Unless full throttle . I have replaced the fuel pump , carb kit , and spark plugs the tank is clean with new lines and gas. I gapped my plugs .030 my points .020 and have great spark and over 90 psi on each cylinder. Can get it to...
Yesterday my tilt trim did strange things. Worked fine until it didn't want to go down. Then later it did go down and up just fine then it didn't want to go up ??? After a bit it decided to start working fine again up and down??? Very confusing I pulled the relays off to see if they were...
Yesterday my tilt trim did strange things. Worked fine until it didn't want to go down. Then later it did go down and up just fine then it didn't want to go up ??? After a bit it decided to start working fine again up and down??? Very confusing I pulled the relays off to see if they were...
My motor barely will start and definetly won't idle I rebuilt carbs and changed the bowls with no change can my problem be in my throttle body or somewhere electrical?
04 johnson 115 first two weeks I had it ran fine then it started idling poorly and starting poorly. At high rpms it runs great I can get it to start in the rev position rev it a few times and it sounds fine let it sit and it slowly gets worse till it quits running . I ran a can of seafoam in...
2004 johnson 115 saltwater series just took carbs off cause my motor wasn't idling and barely starting. at high rpms it's fine , but why would it run fine at high rpms if the float bowls are cracked all four are cracked and warped . One float was way higher then the others and I even found a...
I just bought a 2004 johnson 115 2stroke a month ago . It was running great for like two weeks then it wouldn't start so easy and wouldn't stay running . If I put it in rev mode without the prop engaged it will start but runs rough at low rpms. It runs great at high rpms. I ran a can of sea foam...
I'm looking at buying a 2004 brp saltwater series 115 does anyone have any experience with this motor. It's a friend of mines and I know it runs great and we are going on a test ride Friday but would love any input . He's pretty thorough with his boats so I'd expect it to be tip top.
I've had my 78 evinrude 115 out three times since carbs were redone . First time it started and ran fairly well. Second time put her in full throttle mode and it just runs sluggish and slowly gets better and picks up speed until it's running like normal ? Third time same thing as second time...
My cowling pulled my upper right coil wire out of the coil. I jammed it back in and the motor runs fine . My question is would I be ok to hot glue it back into place or buy a new one? And if one coil is out will it kill both on that side?
