Recent content by Eyedude

  1. E

    Brand new 9.9hp mercury 4 stroke won't start

    Tried squeezing the hard bulb harder until it wouldn't squeeze anymore, then it started! Thx for the responses
  2. E

    Brand new 9.9hp mercury 4 stroke won't start

    yes
  3. E

    Brand new 9.9hp mercury 4 stroke won't start

    put it in forward to give it gas the button would pop back out. Am I doing something wrong?
  4. E

    Brand new 9.9hp mercury 4 stroke won't start

    Thx for the response, I tried all your suggestions but it didn't work. I tried the the push button but when I would
  5. E

    Brand new 9.9hp mercury 4 stroke won't start

    I did everything it said in the manual and it just won't turn over. It has a blinking red light when pulling the pull cord, in the manual it says it's for low oil pressure. I over filled the oil a bit when I put it in but I sucked out the excess. I hope someone can help.
  6. E

    Brand new 9.9hp mercury 4 stroke won't start

    I tried everything according to the manual. There is a blinking red light that goes off when pulling starter rope. In the manual it said something about oil pressure. I over filled the oil a bit when I put it in but had sucked that out. Going nuts can anyone help?
  7. E

    1996 Evinrude 9.9hp 2stoke issue

    I use this as a kicker motor on my boat. I was trolling one day and the motor started chugging and running rough and eventually died after about 30min of fishing. I tried restarting with no luck. I have checked the spark plugs and wires, gas, and oil everything is OK. Still won't start. Any ideas?
  8. E

    1998 Mariner 90 ELPTO Starting Problems

    I have a Mariner 1998 90 ELPTO, Serial # OG748734, which I cant' find anywhere from Mercury material, model# 7-090412GD. I've got a problem with the motor flooding and hard starting. Being a newbie at mechanics, I read tons of info sites and watched videos on You Tube, I thought it was because...
  9. E

    '98 90hp Mariner starter keeps running

    I was out fishing and hit 4 or 5 spots and shut down the engine each time. Called it a day, started engine and drove to the ramp. When I shut down the engine there was a humming sound coming from engine, I disconnected the battery cables and the noise stopped. When I tried to reattach them the...
  10. E

    Grinding noise when turning Minnkota

    I have a Minn Kota 80pd/ap trolling motor that makes a grinding noise when turning. It sounds like it's coming from the drive housing. Could it be the motor-drive or do I need to replace the whole drive housing? Any ideas would be appreciated!
See more
Top