Recent content by feldpaum1975

  1. F

    1989 50HP carborator problem

    I own a 50hp 1989 Force outboard. It runs fine on top end but will not idle? It idles down to far and stalls out before I can put it in gear. I have taken off the carburetor and did what I knew to clean it, which was just spray it out with carb cleaner, took off the float and cleaned...
  2. F

    In need for a 1989 CDI box for force

    I have changed the trigger, and stator in my force and still no spark. Getting spark to the back the only thing I can think still would be wrong would be the CDI box. Would like to buy a working used one if any one has one.
  3. F

    15 hr needing throttle cable

    I have a 15 hp evinrude (Model Number E15RC4D, Serial Number E0657075) with tiller handle, I use it for a kicker trolling motor. It is hooked up to the primary motor with a bar to control steering, but I have no way to control the speed with out walking back and adjusting it. Was wondering what...
  4. F

    15 hp evinrude needing throttle cable

    I have a 15 hp evinrude with tiller handle, I use it for a kicker trolling motor. It is hooked up to the primary motor with a bar to control steering, but I have no way to control the speed with out walking back and adjusting it. Was wondering what it would take to convert just the throttle...
  5. F

    50 hp no spark

    Long story sort I switched my polarities on my battery terminals, and now no spark. It is not a in line fuse or breaker. Was wondering if there was anyway to pin down what I blew, the trigger, stator or coil. Didn't want to just start buying part cause of the coast? Any info would be...
  6. F

    70 hp tunderbolt needing power tilt and trim

    Was wondering if, and if, how much it would cost to put power tilt and tirm on a, I think early 80 late 70's thunderbolt ignition 70hp mercury? Thanks for any info
See more
Top