GOOD NEWS. . . . The PICTURE UPLOAD FUNCTION IS WORKING !!! The tech folks at the parent company have been able to remedy the issue. You can upload pictures once again. Thank you for your patience.
My 1982 evinrude v6 has a mind of its own. I was trouble shooting trying to find out why I have a popping sound when running. I was pulling plug wires when the engine began to rev up. I could not get it to quit until I shut it off. I tried backing down on the timing at idle but it continues to...
Engine runs ok. Very good compresson in all cyliders. Carbs have been taken apart and cleaned. Have not had a chance to put boat in water. However when running on the trailer i get a popping out od the exhaust. When running at 2800 on trailer. Still have some popping. What would cause this?
Motor not firing on port side. I chnage the power pack on port side. Now I have no fire on either side. I have installed a new stator that I had for my 1979 150 eveinrude. The motor I am working on is a 1982 150 evinrude. I have interchange timimg plate and old and new staor with no success. Can...
1979 procraft 17.8. 150 evinrude. Jakeplate and engine set at 3" above bottom of hull. What prop size & pitch would render me the best speed at WOT and hole shot combonation? What is the standard prop size? Any help would be good.
:) How to remove trim motor from engine? Are there bolts on the back side of the trim motor between the pump and the engine bracket? I cannot reach the third screw on the back side of the pump. I have the engine up. I have un bolted the lift arm from the bottom of the motor. I have removed 2...
:rolleyes::) Got a 17.8 procraft Bass Boat 1989. I installed an old 1979 evinrude 150. The boat had a jack plate when I got it. I have had some problems with hard steering at high speeds. I installed new hydrolic steering which helped greatly. However I still have hard steering at WOT. 50mph...
:Confused: I have a 1979 150 evinrude. I have the firing order. However on the plug comimg from the power pack the wires are color coded. Blue, Yellow and green. What cylinders do the colors represent. Going from top to bottom. Is it Blue Yellow Green? If not what order do they go? Starboard side.
1979 evenrude 150. Got fire on all 3 cylinders on left only fire on top cylinder on right. I have installed all new coils. I took a coil off the left and installed on right. Got no fire.
Please help.
1979 evenrude 150. Got fire on all 3 cylinders on left only fire on top cylinder on right. I have installed all new coils. I took a coil off the left and installed on right. Got no fire.
Please help.
