I guess I'm not understanding the wiring diagram above. Where the purple and red/purple go into a splice (I am assuming the resistor) and then to the alternator. From the alternator, there should be 12V there all the time no? So if power is cut from the purple wire, there is still power from the...
Good day!
I have a question about the ignition coil wiring on my OMC Cobra 305.
On the positive terminal, one lead goes to the starter solenoid and the other to the resistor line then to the alternator.
on the ground side, one lead goes to the distributor and the other to the tach.
My...
Engine:
1997 Mercury Sport Jet 175HP XR2
Starting serial numbers: OE272
3 cylinders have the rings seized to the pistons resulting in very poor compression.
I pulled the engine and started taking it apart. I am now down to the crank and ran in to a new problem that I will need some guidance...
I have a 2.5L 1998 Sportjet 175hp XR2.
I need so soak the cylinders in ATF as a last ditch effort to free the rings from the pistons. To do this I need to lay the engine horizontally for the ATF to sit on the pistons and work its way to the rings.
The engine is out now and sitting on a table...
The engine is a 175HP XR2 from a Doral jet boat.
I have low compression on the 3 cylinders on the starboard side.
Port side is 130psi, 130psi, 130psi
Starboard is 20pse, 90psi, 20psi.
I took the head off and this is what the head gasket looks like:
Top cylinder 20psi
Middle cylinder 90psi...
Hey guys!
I just bought a 1998 Doral Jetboat. It has a built in fuel tank. It seems quite large. I would like to know where it is situated in the hull of the boat for two reasons.
#1 my fuel gauge stopped working... So I need to diagnose the sender..
#2 I would like to bolt down an additional...
Good morning!
I hope someone can help me out, I have a 30 HP 97 Evinrude with OMC controls. E30EEUD is my model#.
I woudl like the wiring digrams for the controls. I would like to know if I can tap in a tach and temp guage (or any other gauges and indicators)
Thank you!
Good day guys!
I've just aquired an older boat with a hardly used 1997 30 HP Evinrude E30EEUD with OMC controls.
Unfortunatley, it did not come with the keys... (Estate sale) I found out that a new ignition switch is OMC part # 0175974.
Is there a way to get a key made? or buy a key? (is...
