Is there a maximum length I can have the fuel line on a 25hp e tech? I would like to put my gastank towards the front of my boat for weight distribution but I am not sure if it would be too much stress on the fuel pump.
Joe
I am trying to rebuild my fuel pump which is in pieces right now. I used to have a link to instructions for this but I can't find it anywhere and my searches have turned up empty.Can anybody help me?
Thanks,
Joe
I have a Firestone outboard and was wondering if anyone could tell me the age and approximate value Serial#17255256 Code#133-2-1725 Stock # 10-A-73. It is in great condition with only a few small dents and scratches, I know it turns over and has compression but I have not tried to start it yet...
I just acquired a couple motors which I know nothing about and was wondering if anyone could help me identify them. Also a ballpark estimate of what their worth would be great. I have not started them but they all have compression and turn over freely.
Evinrude 4383-04230 complete
Evinrude...
I just picked up a 4hp Rude from a garage sale for $20 and have was wondering if someone could help me find out the year.
Model#E4RCCS
Serial#B 1625274
Also does anyone know where I could download a manual for free? I have no idea how the cover comes off and don't want to break it. This motor is...
Can someone please point me in the right direction as to where I can get a fuel pump rebuild kit for a 1969 Johnson 20HP? I have searched the site and cannot find one for that year.
Joe
I have a 1969 Johnson 20 HP and to the best of my knowledge it has a original fuel pump in it. Should I replace the pump or will a fuel pump kit be all that I need? When looking at the picture of the kit it didn't seem like it comes with the screen. Also I know before on here I saw a post about...
I have a 69 Johnson 20hp, while trolling the throttle keeps slowing down and I was wondering if there is any way to adjust the tension on it or if anybody has any ideas on how to modify it to make it stiffer? Also the steering tension adjustment keeps backing out also, any ideas?
Joe
Is there anyplace on the internet to pull up exploded parts diagrams for a 1969 Johnson 20hp? I believe a screw on my shift linkage is missing but am unsure.
Joe
Hi all I have searched this site for hours upon hours trying to find my answer and have not found it so please forgive me if perhaps I did over look it. First off the boat is a 1981 Rinker with a OMC 140 3L v4 I/O. A little background, This year we had the motor professionally rebuilt by a...
I have a 1969 Johnson 20hp motor that I did a tune-up on and used a gear puller to remove the flywheel:mad: Needless to say I tweaked it in the process and after I reassembled it it was rubbing and grabbing on the timing plate making it run a little rough. Well I took it out and after a little...
Hi I just rebuilt the carb and replaced the points and condenser's. How it was one side of the points were to spec at 0.020 but the other side was at 0.008? Does anyone have any explanation of this? Before I started this it really did not like to idle at all at low RPM's thats why I did this...
