Recent content by Fishinmission20

  1. F

    Help motor only running on primer!!

    The only problem is have not switched the fuel pump when switching carborators because they are universal so I know that is not the problem. And a carb rebuild kit is 40-50$ for this motor which makes me reluctant since the parts all look good inside
  2. F

    Help motor only running on primer!!

    I meant this primer that goes straight into the carb not the primer bulb, it utilizes the same fuel pump for both hp so I just leave it alone, after i attempt it to run there is fuel in bowl and when I take the primer off fuel comes out. It seems as though fuel can’t get to the engine unless I...
  3. F

    Help motor only running on primer!!

    Everything is from 1998 but the engine block is a 1989 15hp block, the 9.9 carb is from the original 1998 and the 15hp carb is from the 1989. It does not care if the choke is pulled or not it needs primer regardless and all of the jets have been cleaned
  4. F

    Help motor only running on primer!!

    I have a 9.9/15hp force that came with a 9.9 and a 15hp carborator and carb mounting plates. It runs amazing with the 9.9 carb first pull starts good excelleration and speed, but as soon as the 15hp carb is put on it requires the primer to be pushed every few seconds in order to run. This that...
  5. F

    Looking for Gamefisher 9.9 pistons and rods

    Motor blew up last week and need to replace Both pistons one rod and the bearings that go along with the rod. Where can I find this stuff or its equivalent?
Top