GOOD NEWS. . . . The PICTURE UPLOAD FUNCTION IS WORKING !!! The tech folks at the parent company have been able to remedy the issue. You can upload pictures once again. Thank you for your patience.
I purchased an cmc pt-130 since my trim unit was shot that I am about to install it tomorrow. From what I gather the pt-130 uses the existing engine mounts which means also with the existing trim unit for mounting motor to the pt-130, since I'm not going to be using old trim unit is there a way...
According to my shop the internals on my trim unit are bad making my trim unit unrepairable I have tried to locate a used unit online but to no success. Does anyone have any other ideas that can be more affordable a new trim unit is 1200 I am not looking to spend that on a motor of this age.
I put a new trolling motor on my boat and just trying to route the transducer cable and when the motor is in the boat fully pulled up it sat on the transducer cable which is not good, this was the best way I could see to route it anyone have any ideas? If anyone has pictures showing how they...
I have a 97 johnson 40 hp and went to change the impeller, not knowing at first to take bolt off the top of the shift rod we may have done something to the shift rod now it will not come out of forward is something wrong or broken at bottom of shift rod or is it just in wrong?
I have a 97 Johnson 40 hp on a 97 Grumman aluminum bass boat and get a check engine alarm that will go off about every 5-10 min but the boat runs fine and has been checked out by technician any ideas on how to fix this would be great.
