Recent content by FLA BASS

  1. F

    Looking for help !

    I did not test the cap
  2. F

    Looking for help !

    It was a BRP OMS
  3. F

    Looking for help !

    OK, again, thanks to all for the info and help. So the stator checked out. Stator resistance =0.185. The timing/sensor guide (OIS) was sticking, no lube on guide. Fixed that. I took it to the local lake for test run…..RESULTS= It will now start good (1-2 cranks), idle at 800-1000, come up on...
  4. F

    Looking for help !

    Would not start and The carb bowls were full of oil. After 2000 they fail to ”pass” oil rather than the old ones that would ”stop” oil and burn the pistons.
  5. F

    Looking for help !

    Thank You, will attempt today and reply with results
  6. F

    Looking for help !

    Ok guys, so far, the lower unit checks out good. I changed the gear oil and no metal on magnet & oil looked good. Spins free in both directions. I checked the neutral safety switch, it seems to be working properly. The OIS lens is clear with no obstructions, however, it’s sliding bracket seems...
  7. F

    Looking for help !

  8. F

    Looking for help !

    I will check and reply soon. I have taken the day off work to figure this out
  9. F

    Looking for help !

    Yes sir
  10. F

    Looking for help !

    I will check spark today
  11. F

    Looking for help !

    Compression is 130 on all 4 cylinders
  12. F

    Looking for help !

    I have a 2004 Johnson 90 (model j90PLSRR/ Ser. 05070640). Engine starts, idles good @1100rpm in driveway with muffs on. Revs up smooth, no issues. When at boat ramp, it will start, idle, rev up very smooth in neutral, will stall immediately when put in gear (forw.or rev). not “tapering off”...
See more
Top