Recent content by fordmustang

  1. F

    oil injection removal

    I have a 1989 pro v 150 with oil injection, went to test and pump runs all the time. So i got shop book out tested the float's, if i done it right the main oil tank float is bad. Even held both floats in up position it still ran. So this is my question can you remove the system is so how? Has...
  2. F

    lower unit swap

    will a lower unit off of a 250 TXRP fit a 1989 150 prov? if so do i have to change the prop/drive shaft? what years and models fit? any info would be great:D
  3. F

    Carb Upgrade

    I Just Got A Huge Assortment Of Chrysler Parts 2 Days Ago, And In That Was Some 125 And 140 Horse Carbs. So Would The Larger Carbs Make 105 Have More Hp?
  4. F

    Power Trim Lines

    I Took All The Lines Off My Power Trim To Replace Them And Forgot What Went Where. Yeah Didn't Label Them Or Take Them Off One At A Time, Pretty Dumb Of Me. It's On A Chrysler 105 Any Help Would Be Great:d
  5. F

    Tach Install

    I Bought A Tach For A Boat Today, I Would Like To Know How To Wire It Properly. On The Back It Has Three Posts They Are Labled ,ing, Send, Ground. I Am Hooking This To A 72 Model Chrysler 105 Hp. What Wires Go Where Or To What Color?
  6. F

    Top End Woes

    After A Fresh Carbs Rebuild, Took The Boat Out For A Test Run, And This Is How It Went. Great Bottom End, Great Mid Range , But Once On Top End After The Engine Reaches Max Rpm, About Every 15 Sec It Has Dead Spot Or Miss? Until The Rebuild Wouldn't Hardly Get Up On Plane. Any Guesses To What My...
  7. F

    hydrafoil

    This Is A Real Dumb Question, What Is The Real Perpose Of A Hydrafoil, And Are The Worth Buying? I Am A Boat Greenhorn.:d
  8. F

    Tillotson Wb 10d ?

    I HAVE LOOKED AND LOOKED FOR A FLOAT SETTING FOR THIS CARB MODEL NO LUCK YET. ALSO THERE IS 1 SCREW FOR MIXTURE DONT KNOW HOW TO SET IT, IF ANY ONE HAS ANY INFO PLEASE HELP, I TOOK IT OUT TODAY FOR THE 3RD TIME CAN'T SEEM TO GET IT RIGHT?:confused:
  9. F

    carb adjustment

    I HAVE A 72 MODEL CHRYSLER 105 HP, ANYONE KNOW WHAT THE ADJUSTMENTS ARE FOR THOSE CARBS? IT LOOKS LIKE ONLY 1 SCREW IN THE TOP, LOOKING DOWN THE CARB BARREL. RUNS GOOD UNTIL TOP END. IF YOU CHOKE IT, RUNS BETTER, LIKE ITS STARVING FOR GASS? PLEASE HELP:eek:
  10. F

    tirm question

    i have a 72 model chrysler 105 hp. i was wondering 2 things, first can you convert it from electric trim to manual tilt? also if not what is the cheepest place to get a new or used trim motor. i belive the new arco no is 6216 for the motor. would like to find a oem brush rebuild kit for the...
See more
Top