Anybody had good luck with this? What's a good reasonable place to send it to? I have a year old solas stainless 4 blade that I hit bottom and just rolled the edges over. Thank you.
Im trying to align the shaft on the outdrive. I've got it the best I can do but the motor is way off level I have the port side so far up the top nut barely goes on. Then on the starboard side I have it sitting about all the way to the bottom. I had to use the top nut to draw the engine down...
So I'm doing the bellows, senders and new shift cable on a 1990 Alpha 1. I sit the outdrive on its side on a table and a few days later it has leaked out gear oil. It appears its coming from around the driveshaft area. Is this right or does something need fixed? About a month ago I had it at...
So I pulled outdrive after noticing the gasket was leaking and it was taking in water to the driveshaft. Replaced gimbal and seal behind it. Tried putting outdrive back in and it will not go. I aquired an alignment tool and I cant even get it to go into the engine spline. I removed the new...
