Recent content by gdahlber1

  1. G

    1985 Evinrude 150 gas issue

    When I pump the gas ball it fills and gets firm but when I take off the the ball goes flat. What could cause that vaccum? I have checked the dip tube and the change the check valve. I can't find any obstruction anywhere in the system.
  2. G

    Remote control cable connections

    My concealed remote control was mounted on a plastic or starboard board that had broken into 5 pieces. I replaced the board and when I detached the cables I marked which one was on the top and which one was on the bottom. Well I have forgotten how they were attached to the controls. The book...
  3. G

    Micro switch

    I need to replace the neutral safety switch. There is not a part# on the old one. Should I be able to get one from my local Evinrude dealer?
  4. G

    98 Evinrude 150 ficht injector issue

    Does anyone know where I can have my injectors reconditioned or buy rebuilt injectors?
  5. G

    Fuel gauge not working

    How do I troubleshoot my fuel gauge. I read that the round access panel in the deck is where the sending unit is.
  6. G

    1998 150 Ficht problem

    Motor has been starting easily and running great at idle speed and 3000rpm and higher. very rough 20003000rpm-. Yesterday while idling out to the gulf my engine just quit. The motor will turn over and has spark but will not fire. Has anyone had this problem or does anyone have any ideas?
See more
Top