Recent content by GDT

  1. G

    1996 115 Intruder No Oil warning went off while boat was idling.Turn engine off and

    crank it back up and the warning didn't come on the rest of the day, This has happened 3-4 time to me over the last two yrs. Any ideas why this would happen?
  2. G

    Please help me. I changed out my impeller

    and now it takes at least twice as long for the water to drain when I take it out of the water, I've ran the motor hard and it does not run hot, has a strong stream and the water pressure is maxed out at 30 psi +. I have owned this boat since it was new and I never recall this much water...
  3. G

    Does a 1996 115 Evinrude have an o-ring

    at the top of the drive shaft below the splines? I changed my impeller and when I removed the lower unit there was no o-ring on the shaft. I did not see a groove where an o-ring would go either.The Seloc manual says "if used" place the o-ring at the top of the drive shaft. I did put molly lube...
  4. G

    Impeller change question

    It seems like it is taking much longer for the water to drain from my motor after changing the impeller. The stream is strong and I ran it at WOT and the the water pressure gauge was pegging out at 30psi. Is this normal? Could I damage anything? I am new to boating and any advice would be...
See more
Top