Recent content by Glock45

  1. G

    Deck repair question

    Does anyone know of a website that it would give you instructions on how to do repair work on boat decks and maybe illustrations or pictures of before and after results. I just replaced my fuel tank and had to do some cutting on the deck and now I have to repair it and would like to obtain some...
  2. G

    Deck repair question

    Does anyone know of a website that it would give you instructions on how to do repair work on boat decks and maybe illustrations or pictures of before and after results. I just replaced my fuel tank and had to do some cutting on the deck and now I have to repair it and would like to obtain some...
  3. G

    Fuel tank replacement question?

    Need to replace the fuel tank on my 19' Ana Capri. Can any one recomend in the Miami area someone that does fiberglass repair or deck work or maybe that specializes in this kind of things. Really need your help!!!!
  4. G

    Torque Question?

    I am replacing the head gaskets on my 1987, 150-hp Evinrude, but I donnot have a manual for it. Can anyone tell me what torque I need to use when tighten the screws on the heads. <br /><br />Thanks
  5. G

    Impeller question?

    According to the installation instructions of a water pump and housing from OMC for a 150-hp 1988 Evinrude. On the kit they include two thick o-rings about the size of a quoter. Another o-ring a bit smaller that goes all the way on top of the drive shaft. My questions is as follow, I installed...
  6. G

    Water leak problem on 150 Evinrude

    I have the following problem with my 1988, 150-hp, Evinrude. My motor was overheating. I went along and changed the entire water pump housin, thermostats, puppet valves, all deflectors and cleaned all the water channels and the motor is still overheating. I also noticed that there is cold water...
  7. G

    Overheating problem?

    Question? my '88, 150-hp Evinrude was overheating, so I changed the water pump and housing assembly with an after market brand recommended by B&F Marine in Miami. After replacing it, the motor still overheats, not at idle, but at higher RPM's. I replaced the deflectors, the thermostats and...
  8. G

    wiring question

    Hello everyone, I'm new to the forum and I have a little problem and was wondering if anyone can help. On the "heat sensor buzzer" or horn that I have in my boat, there are two cables conected to it, one is beige, which comes from the wire harness from the motor, and the otherone is black with a...
See more
Top