Just picked up a 1988 Sunray Mirage mid-way through the summer. Problem is it has no trailer.
Boat is 4400lbs dry and will be stored on blocks over the winter.
Thoughts on using my oversized ski boat roller trailer with single axle 3500lbs to pull it out and hauling it 100yds to its storage...
Hello all: Have an ongoing problem which is perplexing. 140 Mercruiser approx.1978 MCM 140 Serial #A344469 Not sure if anyone remembers last year when I bought this boat, but had to replace the head gasket as the previous owner overheated it. The following items were replaced during the...
Just a quick question:
Put the boat in the water today. New boat to me and just completed the head gasket repair. Put $20 in as the gas gauge said 3/4 full and brought it up to full.
Boated for about an 1-1/2hr, boat ran great, kids were tubing and all of a sudden hesitation with eventual...
Re: No compression cylinder 2 and 3
It is a rubber flapper in the exhaust to prevent water from back flowing into the engine when you power down. Apparently it will disintegrate if your engine has been overheated.
Re: No compression cylinder 2 and 3
Most parts are in. .024 off the head. Ran a tap through the head bolts and applied perma-tex sealant, tightened to 100lbs ft torque patterned to the manual. Rubber boots for the exhaust have been replace and back flow is still on order. Will have to...
Hi new to the forum sorry if this is redundant. I have read several posts on this but haven`t found the real answer to my question I`m about to ask.
Took a new to us boat out on its second run yesterday and just couldn`t get the boat to run. The first run out, it was hard starting didn`t...
