Hello..I have purchased a boat with a 99 Johnson 90hp on it. it has the plug under the dash for the system check gauge but there is no gauge installed. Do I only need the gauge or do i need to purchase the horn/buzzer as well? Is this horn/buzzer located under the dash or is it on the motor...
I have a 92 Johnson 40hp Model # VJ40TLENM <br />Serial# G 03025505 It is setup as tiller right now, but i beleive before i bought this motor it was setup for steering. I am wanting to make it steering and was wanting to know what is involved and what parts i will need to find..If it was...
I am putting the lower unit on my 92 40hp johnson back together tonight and have a question. I assume i should use some lock tight on the nut on the end of the drive shaft. I do not have the "special tool" for the drive shaft nut so i am just using a thin wall open end wrench. worked fine to...
Hello. I have a 92 Johnson 40hp model #VJ40TLENM and had a bent prop shaft. I got the shaft our and straightened and am now getting ready to put it all back together. I bought the seal kit #18-2694 and have a couple of questions on where a couple of the O rings that come with the kit go...
I am removing the prop shaft from a 40 hp johnson (1992) and have a question..Do i have to remove the drive shaft completly or just take the nut off of the pinion gear to get the prop shaft out? I have everything else out and did not want to go any further until i found out if i had to remove...
Hello...first post but have been lurking for quite some time...<br /><br />I have a 92 johnson 40hp tiller. I have a bent prop shaft and water in the lower unit. I am wanting to go ahead and tear into it and go ahead and replace the water pump all seals etc... I have never tore into a johnson...
