Recent content by gordiegarland

  1. G

    Optimax fuel line size

    Wondering what is the proper fuel line and bulb size diameter to feed a 2011 mercury optimax 90hp 3cyl?
  2. G

    Prop selection

    Can you use a oem yamaha prop on a merc outboard if the diameter and pitch are the same?
  3. G

    Prop selection

    Currently I have a 90 optimax on 1650 fish hawk WT. I am using a 13x19p 3 blade prop and only getting to 5200rpms, little sluggish out of the hole. Motor is operating perfectly Specs say I should be getting up to 5700rpms Should I go to a 13x17p ? Would it be the same diameter and pitch for a 4...
  4. G

    Thru hull aerator livewell pump

    When you install a new thru hull livewell pump, how hard do you torque the lock nut down with your sealant or silicone? the threaded tube and nut are just plastic. is it to be torqued just past hand tight, and allow the silicone to lock the nut?
  5. G

    Teleflex part number

    On my existing steering cable the part number is SSC6273 What is the new number and what length cable is this? this is a Teleflex part number.
  6. G

    1973 evinrude 25hp

    Hello, Where is the thermostat located on this engine 25302A?
  7. G

    73 evinrude 25hp gearcase holes

    On the gearcase, near the OIL LEVEL check screw, there some small holes on either side. Is this normal, are these water drain holes?
  8. G

    73 25hp evinrude carb cleaning

    Hello, I have 1973 Evinrude 25hp sportsman What is the best way to clean the caburator?
See more
Top